Genius 16 / LR Mount to Meanwell LRS STL

These are the STL files for making a 3D printed mounting bracket for the Experience Lights Genius 16 pixel controller GPX16 that attaches to a Meanwell LRS-350 or LRS-600 power supply. The LRS-350 version also features dimples that can be drilled out to accommodate a variety of generic 350W power supplies, offering additional flexibility. The mount also fits the Genius Long Range Pixel Controller GLR and the Genius Long Range Pixel Receiver GR16. The mount features our press fit standoffs and a special support bar that greatly reduces board flex when wiring the spring connectors or clever locks on the controller. The press fit standoffs lock into place and greatly simplify installation as you no longer have loose standoffs that can shift when positioning the board. They need to be printed separately from the primary mount and then aligned over the openings on the deck of the mount and finally simply tapped gently into place until fully seated and secure using a small hammer or mallet. The controller mounting holes are self-threading and sized for 6-32 x 1/2″ screws and the mount attaches to the sides of the power supply using four M4 x 8mm screws. Compatible with our Ammo Box Mounting System v3. Due to the large size of this mount it partially restricts the fan on the power supply, however there is still clearance above the fan and the sides remain open below the controller to allow airflow to pass.

Note: This is a digital purchase for STL files and not a physical product.