$4.00
These are the STL files for making a 3D printed mounting bracket for attaching two four port Genius Receivers GR4 from Experience Lights. The mount attaches to Meanwell LRS-350 or LRS-600 power supplies and also features dimples that can be drilled out to accommodate a variety of generic 350W power supplies, offering additional flexibility. The mount features our press fit standoffs and a special support bar that greatly reduces board flex when wiring the spring connectors or clever locks on the controller. The press fit standoffs lock into place and greatly simplify installation as you no longer have loose standoffs that can shift when positioning the board. They need to be printed separately from the primary mount and then aligned over the openings on the deck of the mount and finally simply tapped gently into place until fully seated and secure using a small hammer or mallet. The controller mounting holes are self-threading and sized for 6-32 x 1/2″ screws and the mount attaches to the side of Meanwell LRS power supplies using two M4 x 8mm screws. Compatible with our Ammo Box Mounting System v3 and Voltage display mounts. The 2024 versions of the receiver and newer share the same mounting hole pattern, while the 2022 and 2023 versions each use different mounting hole locations. All versions are included with the download.
Note: This is a digital purchase for STL files and not a physical product.
Note tolerances on the press fit standoffs are extremely sensitive and a printer that is slightly over extruding or under extruding may produce a fit that is too tight or too loose. If the standoff fit is not satisfactory most slicers include dimensional compensation controls that can be applied to the standoff parts to correct for small variations and achieve the proper press fit.
